Important Notes - Ikelite Digital Housing Supplemental Instructions

Important Notes:

When installing the camera in the housing front, make sure camera is
pushed all the way forward against the front housing ribs before closing
housing. Failure to check this may result in poor camera alignment and
housing controls not engaging properly.
-
Reflections may occur in some photos due to the front camera lens
chrome ring. To assist in reducing reflection, a black vinyl ring is included
with your housing. Remove the protective backing and affix the vinyl ring
to the lens chrome ring.
Zoom Control
Most Ikelite digital point and shoot housings feature a fork style zoom
control as indicated in the general instruction manual, however, the TG-3
housing features a single zoom lever due to space and design
constraints. The lever can only zoom the housing in one direction at a
time. To change the camera's zoom direction, pull the control knob up
and rotate the lever over the camera zoom toggle. Push the knob back
down and rotate in the opposite direction to zoom the other way. After
you have used the housing's zoom lever, it must always be rotated off
the camera's zoom toggle to the "disengaged" position. If the housing
zoom lever is pushing the zoom toggle in either direction, you may not
be able to take a picture due to the camera receiving a signal from the
engaged zoom toggle.
Disengaged
- - - - -
T T
W W
(Olympus TG-3 only)
Engaged Disengaged and
Telephoto) lifted up to rotate
over zoom toggle
- - - - -
T T
W W
Lift knob
to rotate
- -
- - - -
W W T T
Disengaged
- - - - -
T T
W W
Engaged
Wide)
- - -
T T
W W
5