Vent-Axia 9” DESK FAN Assembly & User Instructions

ASSEMBLY & USER
230mm (9") Desk Fan
305mm (12") Desk/Wall mounted Fan
410mm (16") Desk Fan
Please read these instructions carefully before operating the Fan
1) Remove shaft protecting cover and discard. Unscrew guard retaining nut anti-clockwise and remove
from the motor shaft.
2) 12" & 16" models only Turn fan base section over and Pass plug and lead through the centre of
the fan base. Carefully "Click" the 2 sections together, and Fit the securing screws provided. The
Fan lead should also be positioned through the slot in the rear of the housing, this is done by
carefully pushing one side of the slot outwards allowing enough room for the lead to pass.
3) Take the rear guard section and slide it over the threaded screw on the fan body (make sure the
handle on the guard is facing upwards).
4) Screw on the plastic nut to secure the rear guard in place.
5) Push the impeller on to the motor shaft until it reaches the stop.
6) Screw on the impeller retaining cap (Not on 9" fan) in an anti-clockwise direction to secure the
impeller into position.
7) Hook the front guard on to the rear guard section at the top.
8) Secure the two guard sections together with the clips around the edges. The screw and nut at the
bottom of the grille MUST be fitted.
9) For the 12" Desk/Wall mounting fan use suitable fixings for the type of wall the fan is to be mounted
to. Two keyhole slots are provided in the rear of the fan. For wall mounted applications remove the
tilt stop and replace it if required for desk applications.
♦ Ensure that the voltage marked on the underside of the fan agrees with your mains voltage.
♦ This appliance is not intended for use by persons(including children)with reduced physical,sensory
or mental capabilities,or lack of experience and knowledge,unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety
♦ Desk fans are class 1 appliances and MUST BE EARTHED.
♦ The wires in the mains lead are coloured in accordance with the following code:-
BLUE – NEUTRAL
♦ This fan must NOT be used in a bathroom.
♦ Always ensure that a fuse approved to BS 1362 is fitted and that it is the correct rating for the
appliance.
♦ IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN
DESK FAN
LEAFLET

ASSEMBLY INSTRUCTIONS

BROWN – LIVE

IMPORTANT

GREEN/YELLOW – EARTH