Windlass And Anchoring - Hunter 50CC Operation Manual

These types are always positioned with the opening side
of the intake in the forward position. Gravity fed intakes
are the opposite.
Care should be taken that these intakes and pick ups are
cleaned of barnacles and other growth as specified in the
maintenance section of this manual to maintain a clear,
open passageway.
STREET ELL
THROUGH HULL
TH THROUGH HULL NUT
TYP. THRU-HULL W/ SEACOCK DETAIL
The optional electronics package you have ordered on
your boat will largely determine the underwater gear that
is related to the monitoring equipment. Be sure and refer
to your documentation in your owner's packet to find out
the details about this equipment.
6.4 Windlass and Anchoring (Option)
6.4.1 Windlass
Hunter 50
CC
HOSE
DOUBLE CLAMPED
HOSE BARB
BALL VALVE
3/4 (19 MM)
PLYWOOD BACKING
HULL
Fig. 6.8
• Underwater Gear
The windlass facilitates the anchoring of your boat by
automatically raising and lowering the anchor. To oper-
ate the windlass, the windlass breaker at the battery
switch panel must be switched on.
6.4.2 Windlass Operating
Please refer to the equipment's owner's manual for
more details on the winlass specification and operating
instruction.
Note:
It is important that the windlass clutch is tight for proper opera-
tion and safety. Periodically check the clutch and tighten if
necessary.
!
Make sure that the power is off before performing
any maintenance or work on the windlass.
• Periodically check the motor and control box electrical
connections, remove any residue and cover connections
with a small coating of grease.
It is recommended that you, once a year, disassemble
the windlass and remove residue buildup. To perform
6.5
DA NGER
!