In Water Inspection - Hunter 50CC Operation Manual

____ Rubrail sealed secured to hull
____ Sliding hatches drains free of debris
____ Companionway drop-ins fi t properly in companionway and stowage rack
____ Load bearing hardware securely fastened. This includes but is not limited to chainplates, winches and handrails
____ Traveler arch securely fastened. Stainless Steel models should be properly grounded
See owners manual for details
____ Plexiglas hatches, ports, windscreens and windows adjusted and cleaned.
Cleaners and polishers specifi cally for Plexiglas can be purchased from most marine supply stores
____ External teak cleaned and oiled (Teak decking cleaned with mild soap and water)
____ External railings cleaned with soap and water then hand polished using automotive wax
____ All deck fi ll caps seal properly and have retainer chains intact (except Waste Pump-out)
____ Dorade vents or sealing caps installed
____ Topside surface clean and free of gelcoat damage
Interior Inspection
____ Drop-in hatches for bunks and fl oors in place and fi t securely
____ Interior steps and grab rails secured
____ Bilges clean and free of debris
____ Opening port and hatch screens in place
____ Blinds / privacy curtains, shades and interior cushions cleaned, installed and secured
____ All doors open / shut / latch properly
____ Insure all wires and connection on distribution panels are tight (should be
professionally inspected)
____ Television / VCR operational
____ Stereo / Tape / CD operational
____ Chapman's Manual onboard and readily available
____ Safety gear onboard readily available and up to date.
See Chapman's Manual and US Coast Guard website at < www.uscg.mil >for details.
____ Boat owner's manual onboard
Dockside inspection of Engine, Pre-start sequence and operating system
____ Review engine manual for maintenance requirements and proper starting procedure
____ Propeller shaft properly aligned (per engine manual)
____ Shaft to engine coupling bolted and properly torque (per engine manual)
____ All engine mounting bolts in place and properly torque (per engine manual)
____ Crankcase oil at full mark (per engine manual)
____ Transmission fl uid / oil at full mark (per engine manual)
____ Coolant mix ratio proper - heat exchanger and expansion tanks full (per engine manual)
____ Seawater intake valve open and no leaks
____ Air bled from fuel lines and system
____ No fuel leaks at any fi ttings
____ Throttle linkages smooth and operational
____ Shutdown system operational
____ USCG Oil Discharge warning poster in place
____ Exhaust elbows and hoses tight
____ Starting sequence and alarms correct
____ Oil pressure acceptable (per engine manual)
____ Coolant temperature acceptable (per engine manual)
Hunter 50 • Documents and Forms
CC

In Water Inspection

2.7