Troubleshooting; Error Codes And Messages; Internal Device Error Codes; Table 12 - Internal Error Codes - DCS 900E User Manual

dCS 900E / 902E User Manual
dCS Ltd
T S
ROUBLE HOOTING

Error Codes and Messages

Internal Device Error Codes

Manual part no: DOC0029021E1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
The error codes reported by dCS 900 & 902 provide an effective means to
diagnose the majority of problems that may be encountered in use - including
problems with the overall system the unit operates in, internal device warnings
and internal device failures. Please note that through damage or component
failure, the unit self check may fail to operate. If this happens, please contact
your distributor or dCS for assistance.
Sometimes the unit may misbehave. If there is an internal reason, an internal
device error code may be displayed as follows:
Err.xy
an error xy (see table below) has been detected
xy
where values have the following meanings:
Code Description
2
01 E memory (EEPROM) not present
02 Error initialising DSP
03 Error loading DSP
04 Error initialising DSP for coefficients
05 Error initialising DSP for coefficients
06 Error loading DSP coefficients
07 Error loading DSP coefficients
08 Error sending command
09 Error sending command
10 Error sending command
11 Error sending command
12 Error with LSB/MSB configuration
13 Error with LSB/MSB configuration
14 Error with LSB/MSB configuration
15 Error configuring FPGA
99 DSP error

Table 12 - Internal Error Codes

If you get any of these, please contact dCS, with as much information as
possible to help us re-create the problem. Some of these may have hardware
problems as their cause, some may have software.
Manual for Software Versions 1.3x to 1.5x
Page 58
th
12 June 2000
Document No: OS-MA-D0002-902.1E1
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk