Preparation For Shipment - KVH Industries TracVision R4 Owner's Manual

5.5

Preparation for Shipment

If it is necessary to repack the antenna unit for shipment, the
shipping restraints removed during installation must be
replaced. Follow these steps to reinstall the restraints.
1. Remove the radome.
2. Rotate the antenna unit so that the LNB is facing
away from the baseplate connectors.
3. Attach the three restraints to the baseplate using
the -20 x hex screws and washers (provided in
1 ⁄ " 5 ⁄ "
4 8
the kitpack) and nuts (removed from the restraints
during installation) as pictured in Figure 5-8.
4. Place the antenna bracket on the forward shipping
restraint.
5. Secure the forward restraint and bracket by
wrapping two tie-wraps around the bend in the
forward restraint and the antenna bracket (at the
end of the LNB bracket).
6. Replace the radome.
7. Place the entire antenna unit into its shipping box
using the original packaging material. Secure the
box to a pallet to ensure upright transport to KVH.
54-0157 Rev. H
Maintenance
When rotating the azimuth
mechanism by hand, go slowly!
Hitting the mechanical stops with
excessive force will damage the
azimuth limit switch.
Figure 5-8
Attaching the Shipping Restraints
to the Antenna Baseplate
Figure 5-9
Securing the Forward Shipping
Restraint
KVH is not liable for damage
caused by improper shipping.
5-9