KVH Industries TracVision R4 Owner's Manual page 42

A Guide to TracVision R5/R4
TV/SAT Switch LED Indicators
Switchplate Maintenance Port
3-4
Table 3-1
Indicator
Sat A
Error
Sat B
Connecting the TV/SAT Switch
To use the TV/SAT Switch, you must first connect it to the
TracVision system.
1. Connect the TV/SAT Switch's data cable to the
maintenance port on the switchplate (see
Figure 3-4).
Figure 3-4
2. The Sat A and Sat B indicators blink while the
system initializes.
3. Either the Sat A or Sat B indicator will turn solid
green, denoting which satellite is currently being
tracked.
Using the TV/SAT Switch
The TV/SAT Switch is very easy to use. All operations are
controlled through a single button.
To select the second satellite, perform the following steps:
1. Press the Select button on the TV/SAT Switch.
2. The indicator for the current satellite (Sat A or
Sat B) extinguishes, while the indicator for the
other satellite starts blinking.
3. Once the indicator for the other satellite turns
solid green, the TracVision system is tracking the
newly selected satellite. You can now use your
receiver to choose a channel on the new satellite.
Status
Blinking green
Solid green
Blinking red
Blinking green
Solid green
Meaning
Wait – Searching for satellite
Tracking Satellite A
System problem – Refer to
Section 4, "Troubleshooting,"
to find the possible cause
Wait – Searching for satellite
Tracking Satellite B
Maintenance Port
(DB9 Connector)