Installation - KVH Industries TracVision R4 Owner's Manual

2

Installation

Your TracVision R5/R4 is designed for simple installation and
setup. Just follow these easy steps:
Step
1. Choose the hardware locations
2. Mount the antenna unit
3. Connect system components
4. Activate the receiver
5. Select active satellite
6. Set the skew angle (Europe only)
7. Check out system
8. Configure for remote dish use
Tools and Materials Required
• Electric drill
• 3 ⁄ " (5 mm), 5 ⁄ " (4 mm), and
1 6 3 2
and 3 ⁄ " (19 mm) hole saw and auger bit
4
• 1 ⁄ " wrench
2
• #2 Phillips and #0 flat tip screwdrivers
• RG-6 or RG-11 (75 ohms) RF cable (if installing
two RF cables - refer to Section 2.3.5 for details)
• Silicone sealant, RTV, or Sikaflex
• 7 ⁄ " open end wrench
1 6
• Construction adhesive (e.g., Liquid Nails)
• Rivet gun and
suitable for your specific roof construction)
• PC with Windows HyperTerminal or download
the KVH Flash Update Wizard
at www.kvh.com/wizard)
54-0157 Rev. H
Refer to Section...
2.1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
3 ⁄ " (2.5 mm) drill bits
3 2
3
⁄ " (5 mm) rivets (or other fastener
1 6
(available for free
Table 2-1
Installation Process
Plan the entire installation before
proceeding! Take into account
component placement, cable
running distances between units,
and accessibility to the equipment
after installation.
Installation
2-1