Between Satellites; Using The Tv/Sat Switch To Switch - KVH Industries TracVision R4 Owner's Manual

North America
DIRECTV Subscribers
DIRECTV subscribers in certain regions of the United States will
require a DSS Plus receiver to receive broadcasts from multiple
satellites. If connected to the antenna's RF1 connector, the DSS
Plus receiver allows you to switch channels using the remote
control. If you are a DIRECTV subscriber, but do not have a DSS
Plus receiver, or you are using a multiswitch, use the optional
TV/SAT Switch or a PC, as described in the following sections.
DISH Network Subscribers
Most DISH Network customers will need to manually change
satellites using the optional TV/SAT Switch or a PC, as described
in the following sections.
DISH Network customers with DISH 500 service and a DishPro 301
receiver may also use DISH 500 mode. DISH 500 mode automatically
switches between the Echo 119 and Echo 110 satellites when the channel
is changed using the receiver's remote control. To configure your
TracVision R5/R4 for this feature, go to Section 3.4, "DISH 500
Mode."
ExpressVu Subscribers
ExpressVu customers can use the optional TV/SAT Switch or a
PC, as described in the following sections.

3.2.2 Using the TV/SAT Switch to Switch

Between Satellites - Optional
If you're unable to switch between satellites using the receiver
remote control, you can use the optional TV/SAT Switch* (see
Figure 3-3) to easily select between Satellite A and Satellite B.
* To order a TV/SAT Switch (KVH Part Number 01-0245), please call +1 401 847-3327.
TV/SAT Switch Controls and Indicators
The Select button is used for all operator controls. The TV/SAT
Switch also has three LED indicators that show its current status.
Table 3-1 on the following page explains the function of each
indicator.
54-0157 Rev. H
Using Your TracVision R5/R4
Figure 3-3
TV/SAT Switch
Sat A Error Sat B
Select
Changing Satellites:
1. Push Select button
2. Wait while Sat A or
B blinks green
3. Ready when Sat A
or Sat B stays
solid green
Other Indicators:
• Both blinking
green: initializing
• Error light
blinking red:
system problem
3-3