DSDA Digital Storage Disk Arrays
7.1.2
Connecting the Power Supplies
1.
Bosch Sicherheitssysteme GmbH
Set the correct Shelf ID by pressing the + or – button at the back of the shelf, next to the
ID display.
Note: Do not use identical IDs for different shelves.
If not already done, power on the base unit. On the shelf, connect both power supplies
and switch them on. Wait 30 seconds to allow the shelf to initialize.
Make sure that the shelf displays the correct shelf ID on the front display before you
continue.
Installation Guide
Adding Storage | en
21
- | V2 | 2009.11