Miele Heat pump dryer Operating Instructions Manual page 46

Problem solving guide
Problem
 lights up at the end
of a programme
 and  light up after
a programme has been
cancelled
 lights up after a
programme has been
cancelled
 lights up
Bars flash in the display
at the end of a
programme:
.........
46
Cause and remedy
There is a build-up of fluff in the airways.
 Clean the fluff filters.
 Clean the plinth filter.
See "Cleaning and care".
To switch  off:
 Open and close the door while the dryer is
switched on.
An excessive amount of fluff has built up.
 Clean the fluff filters.
 Clean the plinth filter.
Clean the airways:
– Clean the area underneath the plinth filter.
– Clean the heat exchanger.
To switch  off:
 Switch the dryer off and back on again.
The condensed water container is full or there is kink
in the drain hose.
 Empty the container.
 Check the drain hose.
To switch  off:
 Open and close the door while the dryer is
switched on.
The programme selector has been moved.
 Select the original programme. The time remaining
will appear in the display again.
The programme has finished but the laundry has not
yet cooled down.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.