Table of Contents
Advertisement
ECONCEPT SOLAR ST
Compensation curve and curve offset - High Temperature Zone
Press the button
(detail 10 - fig. 1) once to display the actual compensation curve (fig. 11), which can be modified
with the DHW buttons
(details 1 and 2 - fig. 1).
Adjust the required curve from 1 to 10 according to the characteristic (fig. 13).
By setting the curve to 0, sliding temperature adjustment is disabled.
fig. 11 - Compensation curve
Press the heating buttons
(details 3 and 4 - fig. 1) to access parallel curve offset (fig. 14), modifiable with the
DHW buttons
(details 1 and 2 - fig. 1).
fig. 12 - Parallel curve shift
Press the button
(detail 10 - fig. 1) again to exit parallel curve adjustment mode.
Compensation curve and curve offset - Low Temperature Zone with optional Remote Timer Control
connected
Refer to the relevant instruction manual.
Compensation curve and curve offset - Low Temperature Zone without optional Remote Timer Con-
trol connected
Press the ECONOMY/COMFORT button (detail 7 - fig. 1) for 10 seconds; parameter o01 or the actual compensation
curve is displayed, which can be modified with the DHW buttons (details 1 and 2 - fig. 1).
Adjust the required curve from 1 to 10 according to the characteristic (fig. 13). By setting the curve to 0, sliding temper-
ature adjustment is disabled.
Press the heating button (detail 4 - fig. 1) to access parameter o02 or parallel curve offset (fig. 14), modifiable with the
DHW buttons (details 1 and 2 - fig. 1).
Press the ECONOMY/COMFORT button (detail 7 - fig. 1) again for 10 seconds to exit parallel curve adjustment mode .
10
EN
cod. -- - 11/2010 (Rev. 00)
Advertisement
Table of Contents
