Ford TOURNEO COURIER Owner's Manual page 190

1. Select a frequency band.
2. Tune to the station required.
3. Press and hold one of the preset
buttons. A progress bar and message
will appear. When the progress bar
completes the station has been stored.
The audio unit will also mute
momentarily as confirmation.
You can repeat this on each frequency
band and for each preset button.
Note: When you drive to another part of the
country, stations that broadcast on
alternative frequencies, and are stored on
preset buttons, may be updated with the
correct frequency and station name for that
area.
Traffic Information Control
Many stations that broadcast on the FM
frequency band have a TP code to signify
that they carry traffic program information.
Turning Traffic Announcements On and
Off
Before you can receive traffic
announcements, you must press either the
TA or TRAFFIC button. A TA display will
appear to show the feature is switched on.
If you are already tuned to a station that
broadcasts traffic information, TP will also
be displayed. Otherwise the unit will search
for a traffic program.
When traffic information is broadcast, it
will automatically interrupt normal radio
or device playback.
If a non-traffic station is selected or
recalled using a preset button, the audio
unit will remain on that station unless TA
or TRAFFIC is turned off, then on again.
Note: If traffic announcement is on and you
select a preset or manual tune to a non
traffic announcement station no traffic
announcement will be heard.
Tourneo Courier/Transit Courier (C4A) Vehicles Built From: 19-06-2014, M1 Kombi/M1 Kombi Van/N1 Kombi/N1 Kombi Van/Van, ET7J-19A321-AKB (CG3621en) enGBR, Edition date: 04/2014, First P
Audio System
Note: When you are listening to a non
traffic announcement station and turn
traffic announcement off and on again a TP
seek will occur.
Traffic Announcement Volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
To adjust the preset volume use the
volume control to make the necessary
adjustment during an incoming traffic
announcement broadcast. The display will
show the level selected.
Ending Traffic Announcements
The audio unit will return to normal
operation at the end of each traffic
announcement. To end the announcement
prematurely, press TA or TRAFFIC during
the announcement.
Note: If you press TA or TRAFFIC at any
other time it will switch all announcements
off.
News Broadcasts
The audio unit may interrupt normal
reception to broadcast news bulletins from
stations on the FM frequency band, radio
data system or other enhanced network
linked stations.
The display will indicate there is an
incoming announcement, during news
broadcasts. When the audio unit interrupts
for a news broadcast the preset volume
level will be the same as traffic
announcements.
1. Press the MENU button.
2. Scroll to the news option and turn on
or off with the up and down arrow
buttons.
3. Press the OK button to return.
188