Checking The Tire Pressure - Ford TOURNEO COURIER Owner's Manual

13. Remove the power plug F from the
cigar lighter socket or auxiliary power
socket.
14. Quickly unscrew the hose C from the
tire valve. Fasten the valve cap again.
Note: Some residual sealant fluid may drip
or spray out of hose C while you are
disconnecting it. This is normal.
15. Leave the sealant bottle B in the
bottle holder D.
16. Make sure the kit is stored safely, but
still easily accessible in your vehicle.
The kit will be required again when
you check the tire pressure.
17. Immediately drive approximately 2
ml (3 km) so that the sealant can
seal the damaged area.
WARNING
If you experience heavy vibrations,
unsteady steering behavior or noises
while driving, reduce your speed and
drive with caution to a place where it is
safe for you to stop your vehicle. Recheck
the tire and its pressure. If the tire pressure
is less than 15 psi (1 bar) or if there are any
cracks, bumps or similar damage visible,
do not continue driving with this tire.
18. Stop your vehicle after driving
approximately 2 ml (3 km). Check,
and where necessary, adjust the
pressure of the damaged tire.
19. Attach the kit and read the tire
pressure from the pressure gauge E.
20. Adjust it to the specified pressure.
See Technical Specifications
(page 174).
21. Once you have inflated the tire to its
correct tire pressure, move the
compressor switch G to position 0,
remove the power plug F from the
socket, unscrew the hose C and
fasten the valve cap.
Tourneo Courier/Transit Courier (C4A) Vehicles Built From: 19-06-2014, M1 Kombi/M1 Kombi Van/N1 Kombi/N1 Kombi Van/Van, ET7J-19A321-AKB (CG3621en) enGBR, Edition date: 04/2014, First P
Wheels and Tires
22.
23.
Note: Remember that the kit only provides
temporary mobility. Regulations concerning
tire repair after using the kit may differ from
country to country. You should consult a tire
specialist for advice.
the tire pressure until the sealed tire is
replaced. See Technical Specifications
(page 174).
Empty sealant bottles can be disposed of
together with normal household waste.
Return remains of sealant to an authorized
dealer or dispose of it in compliance with
local waste disposal regulations.

Checking the Tire Pressure

Specifications (page 174). Monitor the
tire pressure until the sealed tire is
replaced.
1.
2. Attach the kit and read the tire pressure
164
Leave hose C and H connected to the
sealant bottle B and store the kit
away safely.
Drive to the nearest tire specialist to
get the damaged tire replaced. Before
the tire is removed from the rim,
inform the tire specialist that the tire
contains sealant. You must renew the
sealant bottle B and hose C as soon
as possible once used.
WARNING
Before driving, make sure the tire is
adjusted to the recommended
inflation pressure. You must monitor
WARNING
Before driving, make sure the tire is
adjusted to the recommended
inflation pressure. See Technical
Stop your vehicle after driving about 2
ml (3 km). Check, and where
necessary, adjust the pressure of the
damaged tire.
from the pressure gauge E.