Installation - AEG MCC2581E-m User Manual

9. INSTALLATION

1. Remove any promotion label from
the door.
2. The oven should be installed on a
at, level surface. The surface must
be strong enough to safely bear the
contents. To avoid the possibility of
causing vibration or noise the oven
must be in a stable position.
water. Exposure to heat and water
can lower oven ef ciency and lead to
malfunctioning, so be sure to install
the oven away from heat and water
sources.
4. Do not block air vents on the top
and the sides of the cabinet and
also do not place any articles on
the top of the oven. If air vents are
blocked during operation, the oven
may overheat, and this may lead to
malfunctioning. Hot air escapes from
the vents so be sure not to obstruct
it or let curtains come between the
oven and the rear wall.
5. Place the oven as far away from
radios and TV's as possible. This oven
of radio interference suppression, but
some interference may occur if it is
placed too close to a radio or TV, so
keep them as far apart as possible.
6. If positioned in a corner, leave a gap
of at least 15 cm from the walls and
15 cm above the microwave.
The oven can be placed almost
anywhere in the kitchen. Make
sure the oven is placed on a at,
level surface and that vents as
well as the surface underneath
the oven are not blocked (for
suf cient ventilation).
www.preciz.hu
Connecting to the mains
The oven is delivered with the power
cord and a plug for 230 V, 50 Hz, earthed
socket outlet.
Earth protection minimises the risks
should a short circuit occur. Check to
ensure the voltage of the oven matches
Electrical connections
If the plug that is tted to your appliance
is not suitable for your socket outlet,
please contact service force.
ENGLISH
If the oven is connected to the
socket via an extension cord,
make sure the cord is earthed.
This appliance must not be used
on a non-earth protected power
supply.
Contact an electrician if you are
uncertain regarding electrical
connection of the oven or
provision of earth protection of
the supply.
This appliance must be earthed.
If this appliance is tted with a
non-rewireable plug for which
your socket is unsuitable, the
plug should be cut off and the
appropriate plug tted. If it is
necessary to change the fuse in
a non-rewireable plug, the fuse
cover must be re tted. If the
fuse cover is lost or damaged,
the plug must not be used until
a replacement is obtained.
WARNING! THIS APPLIANCE
MUST BE EARTHED.
The manufacturer declines
any liability should this safety
measure not be observed.
13