Front Panel View Popup Menus; Device Popup Menu; Port Popup Menu - Cisco Catalyst 2950 Software Configuration Manual

Chapter 3 Getting Started with CMS

Front Panel View Popup Menus

These popup menus are available in the Front Panel view.

Device Popup Menu

You can display all switch and cluster configuration windows from the menu bar, or you can display
commonly used configuration windows from the device popup menu
popup menu, click the switch icon from the cluster tree or the front-panel image itself, and right-click.
Table 3-13 Device Popup Menu
Popup Menu Option
1
Device Manager
2 3 4
Delete Cluster
3 4
Remove from Cluster
Bandwidth Graphs
4
Host Name
Properties
1. Available from a cluster member switch but not from the command switch.
2. Available only from the command switch.
3. Available only from a cluster-management session.
4. Not available in read-only mode. For more information about the read-only and read-write access modes, see the
page 3-30.

Port Popup Menu

You can display all port configuration windows from the Port menu on the menu bar, or you can display
commonly used port configuration windows from the port popup menu
popup menu, click a specific port image, and right-click.
Table 3-14 Port Popup Menu
Popup Menu Option Task
1
Port Settings Display and configure port settings.
1
VLAN Define the VLAN mode for a port or ports and add ports to VLANs. Not available for the Catalyst 1900
and Catalyst 2820 switches.
1 2
Port Security Enable port security on a port.
3
Link Graphs Display a graph showing the bandwidth used by the selected link.
Select All Ports Select all ports on the switch for global configuration.
1. Some options from this menu option are not available in read-only mode.
2. Available on switches that support the Port Security feature.
3. Available only when there is an active link on the port (that is, the port LED is green when in port status mode).
78-11380-04
Task
Launch Device Manager for the switch.
Delete a cluster.
Remove a member from the cluster.
Display graphs that plot the total bandwidth in use.
Change the name of the switch.
Display information about the device and port on either end of the link and the state of the link.
(Table
Catalyst 2950 Desktop Switch Software Configuration Guide
Menus and Toolbar
3-13). To display the device
"Access Modes in CMS" section on
(Table 3-14). To display the port
3-21