Cisco Catalyst 2950 Software Configuration Manual page 479

Chapter 24 Configuring QoS
Classifying Traffic by Using Class Maps
You use the class-map global configuration command to isolate a specific traffic flow (or class) from all
other traffic and to name it. The class map defines the criteria to use to match against a specific traffic
flow to further classify it. Match statements can only include ACLs. The match criterion is defined with
one match statement entered within the class-map configuration mode.
You can also create class maps during policy map creation by using the class policy-map configuration
Note
command. For more information, see the
Maps" section on page
Beginning in privileged EXEC mode, follow these steps to create a class map and to define the match
criterion to classify traffic:
Command
Step 1 configure terminal
Step 2
access-list access-list-number {deny |
permit} {source source-wildcard | host
source | any}
or
access-list access-list-number
{deny | permit | remark} protocol
{source source-wildcard | host source |
any } [operator port] {destination
destination-wildcard | host destination |
any} [operator port]
or
mac access-list extended name
{deny | permit} {any | host source MAC
address} {any | host destination MAC
address} [aarp | amber | dec-spanning |
decnet-iv | diagnostic | dsm | etype-6000 |
etype-8042 | lat | lavc-sca | mop-console |
mop-dump | msdos | mumps | netbios |
vines-echo |vines-ip | xns-idp]
Step 3
class-map class-map-name
Step 4 match {access-group acl-index | name
acl-name}
Step 5 end
78-11380-04
"Classifying, Policing, and Marking Traffic by Using Policy
24-18.
Purpose
Enter global configuration mode.
Create an IP standard or extended ACL for IP traffic or a Layer 2 MAC
ACL for non-IP traffic, repeating the command as many times as
necessary.
For more information, see the
section on page 24-14.
For more information on this command, see the
MAC Extended ACLs" section on page
Note Deny statements are not supported for QoS ACLS. See the
"Classification Based on QoS ACLs" section on page 24-5
more details.
Create a class map, and enter class-map configuration mode.
By default, no class maps are defined.
For class-map-name, specify the name of the class map.
Define the match criterion to classify traffic.
By default, no match criterion is supported.
Only one match criterion per class map is supported, and only one ACL
per class map is supported.
For access-group acl-index | name acl-name, specify the number or
name of the ACL created in Step 3.
Return to privileged EXEC mode.
Catalyst 2950 Desktop Switch Software Configuration Guide
Configuring QoS
"Classifying Traffic by Using ACLs"
"Creating Named
23-20.
for
24-17