Setting The Clock; Filler Cap; Overview Of Electronic Speedometer Functions - KTM 400 EXC Owner's Manual

OPERATION INSTRUMENTS
display
12
X SPEED / H
SPEED / CLK
X X
X X SPEED / LAP
X LAP / LAP
SPEED / MAX
X X
X SPEED / ODO
X X SPEED / TR1
X X SPEED / TR2
X X SPEED / A1
X X SPEED / A2
X X SPEED / S1
X X SPEED / S2
If the CLK, LAP, MAX, TR1, TR2 A1, A2, S1 and S2 figures are suddenly cleared, the battery in the electronic speedometer is empty
and must be replaced (see: Replacing the battery in the electronic speedometer).
A tripmaster switch is available as an accessory that lets you control the electronic speedometer functions from the handlebar.
»
OVERVIEW OF THE ELECTRONIC SPEEDOMETER FUNCTIONS
briefly press + button briefly press – button
no function
no function
starts/stops LAP without stops LAP, stores LAP
clearing LAP figure figure, resets LAP to 0
next figure
no function
no function
no function
increases the TR2 figure reduces the TR2 figure
no function
no function
no function
starts - stops S2

Setting the clock

To set the clock, switch the ignition off and select the SPEED/CLK mode. Press
and hold the button for 3 seconds. The blinking digits can be changed
using the + and - buttons. Press the
12 will show the time in the 12-hour mode, 0-24 in the 24-hour mode.
Press and hold the button for 3 seconds to store the settings.
If no button is pressed for 20 seconds, the settings will be stored automati-
cally and the display will return to the SPEED/CLK mode.
+ button
time +
– button
time -
briefly press button changes to the next digit
hold button 3 secs. starts the SETUP menu
stores the time and changes to the SPEED/CLK dis-
play mode
briefly press
no function next display mode
no function next display mode
next display mode
no function next display mode
no function next display mode
no function next display mode
no function next display mode
next display mode
no function next display mode
no function next display mode
no function next display mode
no function next display mode
Filler cap (bayonet cap)
To open the filler cap: Turn the filler cap 45° counter-clockwise.
To close the filler cap: Put the filler cap on and turn it 45 ° clockwise.
button to move to the next digit. 0-
button hold button 3 secs.
displays the SETUP menu
Setting the clock menu
clears all LAP figures
next display mode
clears MAX
next display mode
clears TR1, S1, A1
clears TR2
clears TR1, S1, A1
next display mode
clears TR1, S1, A1
clears S2