Ipod - Yamaha MCR-550 Owner's Manual

TROUBLESHOOTING

iPod

Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod (see
page 9).
Status message
iPod Connecting
iPod Charging
Unknown iPod
iPod
iPod Unplugged
iPod OverCurrent
Problem
No sound.
No sound.
The iPod sounds, but
you cannot operate it
with the unit or the
remote control.
The unit cannot be
operated by the
remote control.
You cannot operate
from the iPod.
The playback
information is not
displayed on the
front panel display.
The iPod does not
charge up.
22
En
Cause
This unit is in the middle of recognizing
the connection with your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
The iPod software is out of date.
The play back of the iPod is finished.
For example, all the songs in the
selected album have finished being
played back.
Your iPod was removed from the iPod
dock.
The connected iPod is not playable on
this unit. The iPod is connected at an
angle.
Cause
The power of the unit is off.
The iPod software version has not been
updated.
The iPod is in the process of connecting
with the unit.
The iPod is set in the iPod dock
improperly.
The iPod is not supported by this unit.
The iPod is not connected correctly.
The iPod software version is out of date.
The iPod is set in the iPod dock
improperly.
The iPod you set is not compatible with
the playback information display.
The iPod is set in the iPod dock
improperly.
The iPod is not supported by this unit.
Remedy
If the message continues to appear in the front panel
display and playback does not start, connect the iPod
again.
Connect the iPod again.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Update the iPod software version to the latest.
Station your iPod back in the iPod dock.
Disconnect the iPod. Change input source other than
iPod and select iPod as input source again. Then
connect playable iPod again.
Remedy
Connect the power cable correctly.
Download the latest iTunes software to update the
iPod software version to the latest.
Please wait for a while.
Remove the iPod from the unit, then set it in the iPod
dock again.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Connect the iPod firmly.
Update the iPod software version to the latest. If the
problem cannot be solved, even with the latest
software, reset the iPod.
Remove the iPod from the unit, then set it in the iPod
dock again.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Remove the iPod from the unit, then set it in the iPod
dock again.
Only iPod (5th generation), iPod classic, iPod nano
and iPod touch are supported.
Page
—
9
—
—
9
9
Page
—
—
—
9
9
—
—
9
9
9
9