Remote Control - Yamaha MCR-550 Owner's Manual

TROUBLESHOOTING
Problem
Playback does not
start immediately
after pressing
on the unit or on
the remote control.
"No Disc" appears in
the display even
though a disc is in
the disc tray.

Remote control

Problem
The remote control
does not work nor
function properly.
■ For U.K. customers
If the socket outlets in the home are not suitable for the plug
supplied with this appliance, it should be cut off and an
appropriate 3 pin plug fitted. For details, refer to the
instructions described below.
Note
The plug severed from the mains lead must be destroyed, as a
plug with bared flexible cord is hazardous if engaged in a live
socket outlet.
24
En
Cause
The disc may be dirty.
The disc loaded into the unit may not be
compatible.
If the unit was moved from a cold to
warm place, condensation may have
formed on the disc reading lens.
The disc loaded into the unit may not be
compatible.
The disc may be dirty.
Disc is loaded upside-down.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on this unit
may be exposed to direct sunlight or
lighting.
The battery may be worn out.
There are obstacles between the sensor of
this unit and the remote control.
Remedy
Wipe the disc clean.
Use a disc supported by the unit.
Wait for an hour or two until the unit adjusts to the
room temperature, and try again.
Use a disc supported by the unit.
Remove the disc and then wipe the disc clean.
Remove the disc and then load the disc with the
labeled side facing up.
Remedy
For information on the remote control operation
range, refer to "Using the remote control".
Change the lighting or orientation of this unit.
Replace the battery with new one.
Remove the obstacles.
■ Special Instructions for U.K.
Model
IMPORTANT
THE WIRES IN MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to
the terminal which is marked with the letter N or coloured
BLACK. The wire which is coloured BROWN must be
connected to the terminal which is marked with the letter
L or coloured RED.
Make sure that neither core is connected to the earth
terminal of the three pin plug.
Page
—
3
—
3
—
—
Page
5
—
5
—