Skoda Amundsen+ Operating Instructions Manual page 6

the on-board voltage of the vehicle or after a fuse failure, the code must be en-
tered before the system can be used again. The code number can only be re-
trieved "online" via the ŠKODA system, as this guarantees even more effective
anti-theft protection. If necessary, visit a ŠKODA Partner
Enter code
If a keypad appears after switching on with the command to enter the code, the
unit must be unlocked by entering the correct four-digit code.
›
Enter the four-digit code using the function keys
in the entry line.
After a four-digit order has been entered, the group of digits will turn grey (inac-
tive) and no further digits can be accepted in the entry line.
›
To delete the digits in the entry line from right to left, press the function key
.
Delete
›
When the correct code is displayed in the entry line, press the function key
Incorrect code number
If an incorrect code is confirmed after entry of the code, the procedure can be re-
peated twice. The number of attempts is shown in the bottom screen line.
If the code is entered incorrectly for the third time, the unit will be blocked for ap-
prox. one hour. It is not possible to enter the safety code again until after one
hour, while the unit and the ignition were switched on.
If three invalid attempts are then made again, the radio navigation system will be
blocked again for an hour.
Note
The code is normally saved in the instrument cluster memory. This ensures that it
is automatically decoded (convenience coding). Manual input of the code is nor-
mally not necessary.
Screen display
The screen of the unit displays information such as information from the Clima-
tronic, the vehicle distance to an obstacle if the "parking aid" has been activated,
etc.
1)
Explanation of terms » Owner's Manual, chapter Foreword.
4
General information
.
1)
to . The digit is accepted
0 9
.
OK

Personalisation
Your vehicle can be equipped with up to four keys. Individual settings of the radio
navigation system area always assigned to the key currently in use. Up to 4 dif-
ferent setting variants can be stored for the radio navigation system. When using
the key for the first time, the factory setting on the radio navigation system is val-
id.
