Daikin Super Multi NX B series Service Manual page 141

Instruction
I To set the clock
1. Press "CLOCK button".
is displayed.
blinks.
2. Press "TIMER setting button"
to set the clock to the present
time.
Holding down "
idly increases or decreases the time dis-
play.
3. Press "CLOCK button".
blinks.
I Turn the breaker ON
• Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
NOTE
I I I I Tips for saving energy
• Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps save energy.
• Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling (heating) effect.
• Clogged air filters cause inefficient operation and waste energy. Clean them
once in about every two weeks.
I I I I Please note
• The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
• If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
• Use the air conditioner in the following conditions.
Mode Operating conditions
COOL Outdoor temperature: <3/4MK>10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
HEAT Outdoor temperature: <3/4MX>–15 to 21 °C
Indoor temperature: 10 to 30 °C
DRY Outdoor temperature: <3/4MK>10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
• Operation outside this humidity or temperature range may cause a safety device to disable the system.
130
" or " " button rap-
If operation is continued out of this range
• A safety device may work to stop the operation.
<3/4MX>–10 to 46 °C (In multi system, it may work to stop the operation of the outdoor unit only.)
<RK(X)>10 to 46 °C • Condensation may occur on the indoor unit and drip.
• A safety device may work to stop the operation.
<RX>–10 to 15 °C
• A safety device may work to stop the operation.
<3/4MX>–10 to 46 °C • Condensation may occur on the indoor unit and drip.
<RK(X)>10 to 46 °C
C
HOME LEAVE
ON/OFF
TEMP
POWERFUL
MODE FAN SWING
SILENT SENSOR
ON CANCEL
OFF
TIMER
Recommended temperature setting
For cooling:26°C – 28° ° ° ° C
For heating:20°C – 24°C
Si12-308
2
1.3
System Configuration