Connecting To An Hdtv With An Hdmi Connector - Cisco Explorer 8600HD Series User Manual

Connecting to an HDTV with an HDMI Connector

WARNING:
Electric shock hazard! Unplug all electronic devices before connecting or
disconnecting any device cables to the set-top.
Required cables:
•
1 HDMI cable
Back of Set-Top
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO
RECEIVE OVER-THE-AIR BROADCAST
SIGNALS. CONNECTION OF THIS DEVICE
IN ANY OTHER FASHION MAY CAUSE
HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN VIOLATION
OF THE FCC RULES, PART 15.
CATV CONVERTER
MADE IN MEXICO
Cable
Input
Important Notes Regarding the HDMI Interface on the Set-Top
The HDMI interface automatically confi gures the audio output for a format supported by the television. Because not all
TVs support the Dolby Digital input, the HDMI interface may automatically select a 2-channel stereo audio confi guration
instead of Dolby Digital, which it carries over to the other digital audio outputs of the set-top. This prevents your home
theater system or Dolby Digital decoder from providing the full Dolby Digital surround-sound eff ect.
You can override this confi guration by completing the following steps.
1. Press SETTINGS twice on the remote control to open the General Settings menu.
2. Press MOVE UP or MOVE DOWN to select the option Audio: Digital Out.
3. Press MOVE RIGHT to select Dolby Digital. This setting will send Dolby Digital audio to the HDMI, DIGITAL AUDIO
OUT, and OPTICAL AUDIO OUT connectors on the set-top.
Notes:
•
If the TV is not Dolby Digital capable, it may not produce audio through its speakers when the Audio: Digital Out
setting on the set-top is set to Dolby Digital. You can either switch the Audio: Digital Out setting back to HDMI
when you are not using the home theater or Dolby Digital decoder, or you can connect the baseband audio
outputs (OUT 1 Audio Left and Right) to the TV.
•
Digital content is encrypted with High-Bandwidth Content Protection (HDCP) on the DVI/HDMI port. This set-top
is not compatible with devices that do not support HDCP. You must use either the YPbPr or 1394 connection to
connect the set-top to these devices.
12
OUTPUT
VIDEO Y
L Pb
R Pr
CABLE IN
Back of
HDTV
S-VIDEO
VIDEO
L/
MONO
AUDIO
R
IN
OPTICAL
AUDIO
DIGITAL
OUT
AUDIO
IR
L
CABLE OUT
R
S-VIDEO
HDMI USB 2.0 eSATA
OUT
AUDIO
CENTER
CHANNEL IN
ON
AUDIO IN
DVI/HDCP
R
VIDEO
Y Y
L/
P L P
B MONO B
AUDIO
R
P P
R R
R
HD 1 HD 2
IN OUT IN
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC
ÉLECTRIQUE NE PAS OUVRIR
120 VAC
60Hz 4.2A
500W
120V~
60Hz 40W
LISTED 36MW
1394 ETHERNET
VIDEO PRODUCT
HDMI
OFF
L
ANT (75 )
ANT-1
L
AUDIO
OUT
R
ANT-2