Connecting To An Hdtv With An Hdmi Connector - Cisco 4240HDC Manual

Connecting to an HDTV with an HDMI Connector

WARNING: Electric shock hazard! Unplug all electronic devices before connecting or
disconnecting any device cables to the set-top.
Required cables:
•
1 HDMI-to-HDMI cable
Explorer Set-top
STB SN: SABNFSRVG
CAUTION eCM MAC: 001868C16907
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC STB RF MAC: 001868C16906
ELECTRIQUE NE PAS OUVRIR
THIS DEVICE IS INTENDED TO
BE ATTACHED TO A RECEIVER
THAT IS NOT USED TO RECEIVE
OVER-THE-AIR BROADCAST
SIGNALS. CONNECTION OF THIS
DEVICE IN ANY OTHER FASHION
MAY CAUSE HARMFUL
INTERFERENCE TO RADIO
CABLE COMMUNICATIONS AND IS IN CABLE
VIOLATION OF THE FCC RULES,
IN OUT
PART 15.
Back of HDTV
Cable Input
Important Notes Regarding the HDMI Interface on the Set-Top
The HDMI interface automatically confi gures the audio output for a format supported by
the television. Because not all TVs support the Dolby® Digital input, the HDMI interface may
automatically select a 2-channel stereo audio confi guration instead of Dolby Digital, which it
carries over to the other digital audio outputs of the set-top. This prevents your home theater
system or Dolby Digital decoder from providing the full Dolby Digital surround-sound eff ect.
You can override this confi guration by completing the following steps.
1. Press SETTINGS twice on the remote control to open the General Settings menu.
2. Press MOVE UP or MOVE DOWN to select the option Audio: Digital Out.
3. Press MOVE RIGHT to select Dolby Digital. This setting will send Dolby Digital audio to the
HDMI, DIGITAL AUDIO OUT, and OPTICAL AUDIO OUT connectors on the set-top.
Notes:
•
If the TV is not Dolby Digital capable, it may not produce audio through its speakers when the
Audio: Digital Out setting on the set-top is set to Dolby Digital. You can either switch the Audio:
Digital Out setting back to HDMI when you are not using the home theater or Dolby Digital
decoder, or you can connect the baseband audio outputs (OUT 1 Audio Left and Right) to the TV.
•
Digital content is encrypted with High-Bandwidth Content Protection (HDCP) on the DVI/HDMI
port. This set-top is not compatible with devices that do not support HDCP. You must use
either the PrPbY or 1394 connection to connect the set-top to these devices.
AUDIO OUT
L
Pr
Pb
IR
R
Y
HDTV DIGITAL VIDEO
S - VIDEO OPTICAL
AUDIO OUT OUT
OUT AUDIO OUT
S-VIDEO
VIDEO
Y
VIDEO
L/
P L
B MONO
L/
MONO
AUDIO AUDIO
R
P
R
R
R
HD 1
IN IN OUT
MULTI-STREAM CABLE CARD
USB 1394 1394
CATV CONVERTER
MADE IN MEXICO
AUDIO
HDMI
CENTER
CHANNEL IN
ON OFF
AUDIO IN
DVI/HDCP
R L
ANT (75 )
Y
ANT-1
P L
B
AUDIO
P
R
OUT
R
HD 2
ANT-2
IN
120 VAC 120 VAC
60HZ 400W 60HZ 40W
LISTED 14H1
CABLE EQUIP.
12