Starting Engine - Yanmar 2TNV70 Operation Manual

CAUTION
Observe the following environmental
operating conditions to maintain engine
performance and avoid premature
engine wear:
• NEVER run the engine if the ambient
temperature is above +113°F (+45°C)
or below +5°F (-15°C).
If the ambient temperature exceeds
◆
+113°F (+45°C) the engine may
overheat and cause the engine oil to
break down.
If the ambient temperature falls
◆
below +5°F (-15°C) rubber
components such as gaskets and
seals will harden causing premature
engine wear and damage.
Contact your authorized Yanmar
◆
industrial engine dealer or
distributor if the engine will be
operated in either temperature
extreme.
• Contact your authorized Yanmar
industrial engine dealer or distributor
if you need to operate the engine at
high altitudes. At high altitudes the
engine will lose power, run rough, and
produce exhaust gases that exceed
the design specifications.
CAUTION
NEVER engage the starter motor while
the engine is running. This may damage
the starter motor pinion and / or ring
gear.
TNV Operation Manual

STARTING ENGINE

Use the following procedure to start the engine.
Note that two typical operator's consoles are
shown for illustrative purposes only.
1. Make sure you follow the procedures stated in
the Daily Checks on page 44.
2. Make sure the fuel filter / water separator fuel
cock (Figure 1, (1)) is in the ON position
(Figure 1, (2)).
0000065en
3. Set the transmission (if equipped) in the
NEUTRAL position.
0000012en
4. Disengage the PTO (if equipped).
5. Set the engine speed control to the mid-
position.
ENGINE OPERATION
c
o
(1)
(2)
0000655A
(1)
(2)
0000012B
Figure 1
53