Adding A Hard Drive In Bay #1 - Digimerge VBAY3HD Instruction Manual

Adding A Hard Drive In Bay #1

Note that the hard drive in Bay #1 is installed upside down, with the underside of the hard drive
exposed.
Bay # 1
Figure 2.8 Internal layout of expansion bay with three hard drives installed. Note that
the hard drive in Bay #1 is upside down. This is the correct way of installing the hard drive.
To install a hard drive in Bay # 1:
1. Remove the two metal brackets by unscrewing the four silver screws underneath the unit.
Hard drive mounting brackets.
Figure 2.9 Remove the two hard drive mounting brackets by removing the four silver screws.
Silver screws
Setting Up The Expansion Bay
Bay # 2
Bay # 3
A hard drive may be installed in
any bay. There is no "Primary"
hard drive bay.
The bays are labeled Bays #1~3
Note!
for description purposes.
9