Basic Setup - Digimerge VBAY3HD Instruction Manual

Basic Setup

BASIC SETUP
1. UPGRADE THE FIRMWARE
a. Upgrade the Blade with the included
firmware. See "Upgrading The Firmware"
on page 4.
The Blade requires a firmware upgrade
in order to detect the expansion bay.
2. CONNECT THE GROUNDING
CABLE
a. Connect the grounding cable from the
rear panel of the expansion bay to the
rear panel of the Blade. Screw the
grounding cable into the Ground port to
secure (Figure 1.0).
3. CONNECT THE USB CABLE
a. Connect the included USB cable from the
rear panel of the expansion bay to the
rear panel USB port on the Blade.
TIP: The bottom USB port on the rear panel of the
Blade offers faster transfer rates.
NOTE: It is highly recommended to use the
included USB cable for the expansion bay to
function properly.
4. POWER ON THE EXPANSION
BAY
a. Connect the power cable to the DC 12V
port on the rear panel of the expansion
bay (Figure 1.2).
5. POWER ON THE BLADE
a. Turn on the Blade to start configuring the
expansion bay.
2
Figure 1.0 Connect the grounding cable from the expansion
bay to the Blade.
Figure 1.1 Connect the USB cable to the Blade and expansion
bay.
Figure 1.2 Connect the power cable