Setting The Expansion Bay To Record Events - Digimerge VBAY3HD Instruction Manual

Setting Up The Expansion Bay
Select Recording Mode
1. Select RECORD from the main menu. Press
ENTER on the remote. The Record menu
opens.
2. Select BACK UP MODE. Change the value to
OFF. Press f(-) or f(+) on the remote to
change the values.
3. Press the ESC button on the remote until a
window prompts you to save. Select SAVE
AND EXIT. Press ENTER on the remote.
The overwrite option must be enabled
NOTE:
so that the system records on a continual loop.

Setting The Expansion Bay to Record Events

You can set the expansion bay to store events only. For example, you can set the expansion bay to
store all Motion events. This allows you to save hard drive space.
To configure your expansion bay to record events:
Configure the expansion hard drives
1. Press (Menu) on the remote to open the
main menu.
2. Select SYSTEM. Press ENTER on the remote.
3. Select HDD. Press ENTER on the remote.
4. Select HDD CONFIGURATION. Press ENTER
on the remote. A window opens with a list of
hard drives (Figure 2.1).
• Hard drives labeled FIXED-00 and FIXED-01
refer to the hard drives in the Blade.
• Hard drives labeled FIXED-02, FIXED-03 and
FIXED-04 refer to the hard drives in the
expansion bay.
5. Select FIXED-02. Change the setting to
BACKUP by pressing the f(-) or f(+) button on
the remote.
Repeat for FIXED-03 and FIXED-04 if desired.
6. Press the button on the remote until you reach the main menu.
ESC
Select Recording Mode
1. Select RECORD from the main menu. Press ENTER on the remote. The Record menu opens.
2. Select BACK UP MODE. Change the value to EVENT. Press f(-) or f(+) on the remote to change
the values.
3. Press the ESC button on the remote until a window prompts you to save. Select SAVE AND
EXIT. Press ENTER on the remote.
6
Figure 2.0 Record setup menu. Select OFF under BACKUP
MODE.
Figure 2.1 HDD Configuration menu.
Figure 2.2 Record menu. Select EVENT under
BACKUP MODE.