Bios Setup Utility - Fujitsu Primergy BX600 Start Manual

n Setting Switch Blade
Perform default settings such as password for each installed Switch Blade. For details, refer to "PRIMERGY
BX600 LAN Switch Blade Document CD".
Do not set VLAN at this time.
n Setting Server Blade
Power on the server blade, and perform settings for the BIOS Setup Utility as required. Set for each installed
blade.
������������ "Chapter 8 Hardware Configuration/Utilities"
Before powering on, be sure to check that the CD-ROM drive and floppy disk drive are connected to the server blade where
software will be installed, and that a display is connected to the chassis.
lBIOS Setup Utility
Change the settings in the following cases:
- When changing a drive which boots up this server
- When performing remote installation
- When optional devices are installed
You can write down hardware configuration and setting
values of the BIOS Setup Utility in the
"
Sheets that is available from Fujitsu PRIMERGY website
(http://primergy.fujitsu.com).
1
Prepare the ServerStart CD-ROM.
2
Turn on the server blade, and insert the
ServerStart Disc1 CD-ROM immedi-
ately.
1. Press the power switch of the server blade.
�������������������������
Press the CD-ROM eject button (OPEN), and
2.
insert the ServerStart Disc1 CD-ROM.
"
Configuration
����������
�����������
3
Set the hardware.
If no hardware settings are performed, skip to the
next step when a message to insert the ServerStart
floppy disk is displayed.
l BIOS Setup Utility
1. If the "Press F2 to run Setup" message
appears during server startup (during POST),
press [F2] while the message is being
displayed.
2. Check/change the BIOS settings.
3. Select "Save Changes & Exit" from the Exit
menu and press [Enter].
4. Move the cursor to "Yes" using [←] [→] and
press [Enter].
For the use of Linux distribution with this server,
refer to the Fujitsu PRIMERGY website (http://
primergy.fujitsu.com).
6