Floor Protector And Mantel-Shelf Reqts; Mantel-Shelf Shielding - Masport HORIZON Owner's Manual & Installation Manual

FLOOR PROTECTOR AND MANTEL-SHELF REQUIREMENTS
MINIMUM FLOOR PROTECTOR SIZES (mm)
NZ LE 3000 Provincial
Australia LE 3000 Provincial
NZ and Aust LE 7000 Provincial
NZ and Aust. Grande Provincial
MANTEL-SHELF DIMENSIONS and SIDE WALL CLEARANCES (mm)
NZ LE 3000 Provincial
Australia LE 3000 Provincial
NZ and Aust. LE 7000 Provincial
NZ and Aust. Grande Provincial

MANTEL-SHELF SHIELDING

Mantel-shelves wider or lower than those specified above can be used provided that they are fitted
with metal heat shields below them. We recommend a sheet metal shield fixed 20mm below the
undersurface of the shelf on non-combustible spacers. The shield must abut the wall beneath the
mantelshelf and protect the entire depth of the under-surface of the shelf. It must extend outwards at
least 200mm from each side of the appliance or to the ends of the shelf if this is a shorter distance.
The 20mm air space under the shelf must be open at the ends and front to allow free circulation.
H
X to surround
X to glass
W
H
X to surround
X to glass
W
H 47 or more
X to surround
X to glass
W
94 or more
H
X to surround 335
X to glass 300
W
A minimum B
225 810
225 810
180 1000
185 1095
11
«
NOTE: Where a floor protector is shown
as having zero height, its dimensions
define the limits to which a heat sensitive
floor covering may extend toward the
heater. Since the floor within these
boundaries will have no protective
insulation, it will need to be heat
resistant (e.g.concrete with no timber
in contact).
60 or more 50
300 325
330 355
Any height
375
405
935
44
330 336
300 306
935
75 50
373 418
338 383
965
C minimum D minimum
295
565
565
260
590
290
590
25 Zero «
400 450
430 480
935
37.5 25 Zero «
349 373 430
319 343 400
44 25 Zero «
429 466 500
394 431 465
E maximum
955 75
1225 250
1225 250
980 150
1310 250
1080 150
1380 250