Free-Standing Models - Installation; Unpacking; Assembly; Pedestal - Masport HORIZON Owner's Manual & Installation Manual

FREE-STANDING MODELS

UNPACKING

After removal of the shipping carton, open the door and lift it from its hinges. Do not remove the
polystyrene packers above the top baffle at this stage. Do NOT discard the top baffle. Remove the
pedestal components from the firebox in the case of fires requiring pedestal assembly.
Remove and discard the four bolts holding the woodfire to the shipping pallet.
Remove the woodfire from the pallet, lifting only from the lower edge of each side.
DO NOT LIFT BY THE LOWER FRONT PANEL OR THE REAR PANEL.
ASSEMBLY OF FREE-STANDING MODELS
The table inside the front cover of this guide will help you identify the various fastenings.
PEDESTAL. Some models are shipped with the pedestal dis-assembled
is to assemble the pedestal. Secure the two pedestal sides to the front, using four M6x12 set screws
and taking care that the bottom flanges of the side panels align with the bottom flange of the front
panel. The side with the square hole for the fan switch goes on the right (as viewed when looking at
the front of the front panel). The top flange of the front panel will be above the top flanges of the side
panels. Fit the slotted pedestal rear panel using the four black 12mm long self threading screws (sharp
points).
FAN. If you intend installing a fan (available as an accessory), assemble the pedestal completely to the
heater (if not already assembled). The fan is best fitted after the fire has been moved close to its final
position. Then remove the rear pedestal panel and install the fan instead of the rear panel.
BOTTOM HEAT SHIELD. Using the four zinc plated 12mm long self threading screws (blunt
points), screw the heat shield to the top of the pedestal assembly with the turned up ends of the heat
shield facing upwards. Check that the pedestal foot and trim (if any) will fit snugly around the
assembled pedestal before tightening all assembly screws fully.
Roll the woodfire carefully onto its back, using the flattened carton to protect the floor.
Taking care that the slotted pedestal rear panel will be at the rear, attach the pedestal and heat shield
assembly to the firebox using the four M6x 35 set screws, four M6 flat washers and four M6
Hexagon nuts. Place the washers on the set screws and pass the screws from inside the firebox
through the holes in the pedestal. In the case of the Horizon, Siena and LE 2000, two of the screws
pass through holes in the heat shield. The nuts will be inside the pedestal. Check the alignment of the
pedestal before tightening the nuts firmly.
Roll your woodfire carefully back into the upright position.
(See page 11 for in-built models)
3
.
For these ones, the first step