Table of Contents
Advertisement
INPUT
AND OUTPUT
CONNECTIONS
CAUTIONS: When making connections
to this
or any other component,
make sure
all components are OFF. Make sure all cable terminations
are of the highest
quality, free from frayed ends, shorts, or cold solder joints.
1. Connect the left
and right
outputs
of your source components to the input
on the KRC-3.
The KRC-3 is equipped
with four single-ended
inputs
(S1, $2, S3/proc,
and
S4/tape)
and one balanced
input
(B1).
The S1 and $2 inputs
are standard
single-ended
inputs
while
S3/proc
and S4/tape
have user-configurable
options.
The S3/proc
and S4/tape
are
set
as standard
inputs
from the
factory.
The S3/proc
input
can be set
for use as a surround
processor
throughput
and the
S4/tape
can be set
as a tape
monitor
input.
Both
options will be discussed
on page 6 in Optional Configurations.
2. Connect the output
of the KRC-3 to the input
of your power amplifier.
The KRC-3 has balanced
outputs
via XLR type connectors
and single-ended
outputs
via RCA type connectors.
Both outputs
are active
at all
times,
allowing
simultaneous
connection
to separate
amplifiers.
Only one of these
outputs should be connected to a single stereo amplifier.
NOTE: When connecting
inputs
or outputs
to the KRC-3, remember that
the
balanced
connections
will
have 6dB more gain than the
single-ended
connections.
When level
matching is critical
in your installation,
keep this
specification
in mind.
3. Plug the AC cord into
the receptacle
on the back of the KRC-3. Plug the
remaining
end into
the
AC wall
receptacle.
The blue
pilot
LED will
illuminate,
and the KRC-3 will be ready for operation.
4
Hide quick links:
Advertisement
Table of Contents
