WARNING! Do not place the component where it could be exposed to dirt or excessive moisture. The ventilation grids on the top, bottom, and sides of the KMA-i800 must be unobstructed at all times. Do not place flammable material on top of or beneath the unit.
AC Power Guidelines The KMA-i800 requires a dedicated AC circuit rated at a minimum of 20 amps for 100-120VAC operation or 13 amps for 220-240VAC operation. Do not use extension cords, adapters, or power strips. Krell does not recommend the use of power conditioners with the KMA-i800.
When the KMA-i800 is in stand-by the Web page will be grayed-out and only the Power button will be active. Click on the Power button to turn on the unit. The KMA-i800 will turn on and a few seconds later the Web page will come up to full brightness and various status information will be displayed.
Page 10
From time to time Krell may release new versions of software to add features or fix a problem. The KMA-i800 must be connected to the LAN router with access to the Internet in order to perform the software update. With the KMA-i800 in stand-by press and hold the power button until the green stand-by lights begin to flash;...
Disconnect the speaker wires and turn the system volume down to zero. Turn on the KMA-i800 again. If it stays on, turn it off and re-connect the speaker wires. Turn it back on and slowly increase the system volume.