Heatilator ECO-ADV-PS35 Installation Manual
Heatilator pellet burning stoves installation manual
Hide thumbs
Also See for ECO-ADV-PS35:
- Owner's manual (60 pages) ,
- Owner's manual installation and operation (56 pages) ,
- Owner's manual (40 pages)
Table of Contents
Advertisement
INSTALLER: Leave this manual with party responsible for use and operation.
OWNER: Retain this manual for future reference.
PELLET BURNING STOVES
Model(s):
ECO-ADV-PS35
ECO-ADV-PS50
ECO-CAB50
CAUTION
Tested and approved for wood pellets, Burning of any
other type of fuel voids your warranty.
CAUTION
Check building codes prior to installation.
• Installation MUST comply with local, regional, state and na-
tional codes and regulations.
• Consult local building, fi re offi cials or authorities having juris-
diction about restrictions, installation inspection, and permits.
www.heatilatorecochoice.com
Consumer Care 1-800-926-4356: Prior to calling, please
have the model and serial number of the unit you are call-
ing about. Information can be found at the rear of the unit.
1
Installation Manual
Installation & Appliance Set-Up
NOTICE: DO NOT DISCARD THIS MANUAL
If the information in these instruc-
tions is not followed exactly, a
fi re could result causing property
damage, personal injury, or death.
• Do not store or use gasoline or other fl am-
mable vapors and liquids in the vicinity of
this or any other appliance.
• Do not overfi re - If heater or chimney con-
nector glows, you are overfi ring. Overfi ring
will void your warranty.
• Comply with all minimum clearances to
combustibles as specifi ed. Failure to
comply may cause house fi re.
Hot glass will cause burns.
•
Do not touch glass until it is cooled
•
NEVER allow children to touch glass
•
Keep children away
•
CAREFULLY SUPERVISE children in same room as
fi replace.
•
Alert children and adults to hazards of high temperatures
•
High temperatures may ignite clothing or other
fl ammable materials.
•
Keep clothing, furniture, draperies and other fl ammable
materials away.
To obtain a French translation of this manual, please contact
your dealer or visit www.quadrafi re.com
Pour obtenir une traduction française de ce manuel, s'il vous
plaît contacter votre revendeur ou visitez www.quadrafi re.com
7058-205A
WARNING
WARNING
HOT SURFACES!
Glass and other surfaces are hot
during operation AND cool down.
NOTE
6/16/2014
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Heatilator ECO-ADV-PS35
Summary of Contents for Heatilator ECO-ADV-PS35
- Page 1 PELLET BURNING STOVES fi re could result causing property damage, personal injury, or death. Model(s): ECO-ADV-PS35 • Do not store or use gasoline or other fl am- mable vapors and liquids in the vicinity of ECO-ADV-PS50 this or any other appliance.
-
Page 2: Table Of Contents
H. Pellet Venting Charts ............15 I. Venting Termination Requirements ........16 NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifi cations and/or price without notice. Heatilator a registered trademark of Hearth & Home Technologies. 7058-205A 6/16/2014... -
Page 3: Important Safety Information
*BTU will vary, depending on the type of fuel you use in your For assistance or additional information, consult a qualifi ed appliance. Consult your Heatilator dealer for best results. installer, service agency or your dealer. 6/16//2014... -
Page 4: Getting Started
HEATILATOR ECO-CHOICE Install Guide Getting Started A. Design, Installation & Location Considerations Since pellet exhaust can contain ash, soot or sparks, you must consider the location of: 1. Appliance Location • Windows NOTICE: Check building codes prior to installation. • Air Intakes •... -
Page 5: Thermostat Wall Control Location
HEATILATOR ECO-CHOICE B. Thermostat Wall Control Location WARNING The thermostat wall control’s location will have some affect on the appliance’s operation. Hearth & Home Technologies disclaims any responsibility for, and the warranty will be • Maximum wire length from appliance is 100 feet (30.48m) voided by, the following actions: continuous unspliced wire. -
Page 6: Install Checklist
HEATILATOR ECO-CHOICE E. Install Checklist ATTENTION INSTALLER: Follow this Standard Work Checklist This standard work checklist is to be used by the installer in conjunction with, not instead of, the instructions contained in this installation manual. Customer: Date Installed: Lot/Address:... -
Page 7: Dimensions And Clearances
HEATILATOR ECO-CHOICE Dimensions and Clearances A. Appliance Dimensions MODEL: ECO-ADV-PS35 22-1/4 in. (565mm) 8-3/4 in. 2-3/8 in. (223mm) (60mm) 31-3/4 in. (806mm) 28 in. 22-15/16 in . (711mm) (583mm) 24-13/16 in. (630mm) 20-1/4 in. (514mm) Figure 7.1 - Top View Figure 7.2- Front View... - Page 8 HEATILATOR ECO-CHOICE MODEL: ECO-ADV-PS50 24-1/4 in. (616mm) 9-3/4 in. 2-3/8 in. (248mm) (60mm) 35-3/4 in. (908mm) 32 in. (813mm) 26-7/16 in. (672mm) 28-5/16 in. (719mm) 20-1/4 in. (514mm) Figure 8.1 - Top View Figure 8.2- Front View 4-3/8 in (111mm)
- Page 9 HEATILATOR ECO-CHOICE MODEL: ECO-CAB50 2-3/8 in 23-3/4 in [603 mm] [60 mm] 36-1/2 in [927 mm] 24-1/2 in [622 mm] Figure 9.1 - Top View Figure 9.2- Front View 25-7/8 in [657 mm] 4-3/8 in [111 mm] 3-1/8 in [79 mm]...
-
Page 10: Clearances To Combustibles (Ul And Ulc)
HEATILATOR ECO-CHOICE C. Hearth Pad Requirements (UL and ULC) B. Clearances to Combustibles (UL and ULC) Use a non-combustible fl oor protector, extending beneath appliance and to the front, sides and rear as indicated. Mea- sure front distance “M” from the surface of the glass door. -
Page 11: Vent Information
HEATILATOR ECO-CHOICE Vent Information A. Venting Termination Minimum Requirements Electrical Service Inside Corner FIXED FIXED OPEN CLOSED CLOSED OPEN J or K Figure 11.1 Termination Cap Air Supply Inlet Restricted Area Gas Meter All minimum clearances are listed with an Outside Air Kit (OAK) installed, unless otherwise noted in table below. -
Page 12: Avoiding Smoke And Odors
HEATILATOR ECO-CHOICE B. Avoiding Smoke and Odors Vent Confi gurations To reduce probability of reverse drafting during shut-down Negative Pressure, Shut-Down and Electrical Power conditions Hearth & Home Technologies strongly recom- Failure mends: To reduce the probability of back-drafting or burn-back in •... -
Page 13: Negative Pressure
HEATILATOR ECO-CHOICE C. Negative Pressure Minimum Vacuum Requirements per Unit Negative pressure results from the imbalance of air avail- Minimum Vacuum MODEL able for the appliance to operate properly. It can be strongest Requirements in lower levels of the house. -
Page 14: Equivalent Feet Of Pipe
HEATILATOR ECO-CHOICE F. Equivalent Feet of Pipe WARNING The table below can help you calculate the equivalent feet Vent surfaces get HOT, can cause burns if of pipe which is a method used to determine pellet vent size. touched. Non-combustible shielding or guards Figure 14.1. -
Page 15: Pellet Venting Charts
HEATILATOR ECO-CHOICE H. Pellet Venting Charts WARNING The maximum horizontal venting allowed with no vertical vent- ing attached is 48 inches (1219mm) including one 90° elbow Fire Risk. or two 45° elbows. This is our recommended horizontal vent- • Only LISTED venting components may be used. -
Page 16: Venting Termination Requirements
HEATILATOR ECO-CHOICE I. Venting Termination Requirements CAUTION Do not terminate vent in any enclosed or semi-enclosed area such as a carport, garage, attic, crawl space, under a sun deck or porch, narrow walkway or closely fenced area, or any location that can build up a concentration of fumes such as a stairwell, covered breezeway, etc. -
Page 17: Venting Systems
HEATILATOR ECO-CHOICE Venting Systems A. Alcove Installations Into Alcove All minimums listed are to a combustible surface. Minimum Maximum Model: PS35 Inches Millimeters Inches Millimeters Height 51-3/4 1314 Width 50-1/4 1276 Depth 1219 Side Wall Mantel Depth Minimum Maximum Model: PS50... -
Page 18: Vertical - Interior - Typical Installation
HEATILATOR ECO-CHOICE C. Through The Wall & Vertical - External B. Vertical - Interior - Typical Installation PREFERRED METHOD #2 PREFERRED METHOD #1 Rain Cap Rain Cap 12 in. 12 in. Flashing (305mm) Flashing (305mm) Minimum Minimum Firestop 2 in. (51mm) Minimum... -
Page 19: Through The Wall
HEATILATOR ECO-CHOICE E. Through The Wall Horizontal termination cap must be a minimum of 6 inches. In Canada, where passage through a wall or partition of (152mm) from the wall. Approved for mobile home instal- combustible construction is desired, the installation shall lations. -
Page 20: Masonry
HEATILATOR ECO-CHOICE WARNING Fire Risk Inspection of Chimney: • Masonry chimney must be in good condition. • Meets minimum standard of NFPA 211 • Factory-built chimney must be a minimum 6 inch (152mm) UL103 HT. F. Masonry Fireclay flue Concrete Cap... -
Page 21: Appliance Set-Up
HEATILATOR ECO-CHOICE Appliance Set-Up A. Outside Air Kit 2 Inch Outside There are two Outside Air Kits that will work with this appli- Air Kit Shown ance. One kit, 811-0872 uses a 2 inch fl ex hose (included) and uses hose clamps to secure the hose. The other kit, OAK-3, uses a 3 inch fl... -
Page 22: Top Vent Adapter Installation
HEATILATOR ECO-CHOICE Top Vent Adapter Installation C. Rear Vent & Rear Vent to Top Vent Adapter Installation 3 to 3 inch Top Vent Adapter 3 to 6 inch Top Vent Offset Adapter Put a layer of high temperature silicone on the 3 inch (76mm) exhaust outlet. -
Page 23: Thermostat Installation
HEATILATOR ECO-CHOICE D. Thermostat Installation A low voltage thermostat is required to operate this CAUTION pellet appliance. You may use the included wall mount Shock hazard thermostat (Figure 23.2) or purchase an optional pro- • Do NOT remove grounding prong from plug. -
Page 24: Mobile Home Installation
HEATILATOR ECO-CHOICE Mobile Home Installation You must use a Quadra-Fire Outside Air Kit CAUTION for installation in a mobile home. THE STRUCTURAL INTEGRITY OF THE MOBILE HOME An outside air inlet must be provided for the combustion air and FLOOR, WALL AND CEILING/ROOF MUST BE MAINTAINED must remain clear of leaves, debris, ice and/or snow. -
Page 25: Accessory List
HEATILATOR ECO-CHOICE Accessory List ECO-ADV-PS35 Service Parts Beginning Manufacturing Date: Apr 2010 Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Stocked Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. -
Page 26: Service Parts
HEATILATOR ECO-CHOICE ECO-ADV-PS50 Service Parts Beginning Manufacturing Date: Apr 2010 Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Stocked Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. - Page 27 HEATILATOR ECO-CHOICE ECO-CAB50 Service Parts Beginning Manufacturing Date: May 2011 Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Stocked Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
-
Page 28: Contact Information
Hearth & Home Technologies 1445 North Highway Colville, WA 99114 Division of HNI INDUSTRIES Please contact your Heatilator Eco-Choice dealer with any questions or concerns. For the number of your nearest Heatilator dealer log onto http://www.heatilatorecochoice.com/ CAUTION DO NOT DISCARD THIS MANUAL...
Need help?
Do you have a question about the ECO-ADV-PS35 and is the answer not in the manual?
Questions and answers