Electron ANALOG 4 Reference Manual page 9

Playing a Sound
Simulating a Chord Sound
Editing a Synth Sound
Adding FX to Sounds
Quick Save & Reload of Track
Use the Keyboard Keys to play a sound
C# D# E# F# G#
●● ●●●
○○○○○○○○
C1 D E F G A B C2
[˄] [˅] keys to move the keyboard octave up and down. Octave Led
Use the
on the left of the keyboard shows current position
th
1. Select '5 ' as Sub Oscilator Type
This will play a note 7 semitones below when playing notes
1. Select a track with sound to edit by pressing [Trk 1], etc
2. To change the Track level use (LEVEL) Control (Left hand bargraph on
display shows set level)
3. Select PARAMETER page to edit [Osc1, Osc2, Filters, Amp, Env, LFO]
4. Display changes to show the selected parameter list. Where 2 pages
exist pressing the PARAMETER again will change to page 2.
See configuration section to see location of sound parameters.
120
Level for Track
■
KIT
g g g g - - - - YAZOO YAZOO YAZOO YAZOO
_ _ : [ A01
A01 A01 A01 A01
Chorus, Delay and Reverb are available on the FX track. See the
configuration section for order of effects.
1. Select a track with sound to edit by pressing [Trk 1], etc
2. Select the Amp section by pressing [AMP]
3. Adjust the control for (CHO) (DEL) (REV) to change the send amount.
4. Select the [FX] Track 5
5. Switch to the selected effect by pressing the [Chorus],[Delay], [Reverb]
button (these are indicated in grey under the performance buttons)
6. Adjust the effect settings as desired.
Note: The chain of effects means that Chorus signal can be routed to Delay
and Reverb, Delay signal can be routed to Reverb.
1.Press [Yes/Save] + [KEYBD E1] i.e.Track for Quick Save
1. Press [No/Reload] + [KEYBD E1] i.e.Track for Quick Reload
Page No Bar
OSC1 TUN FIN DET TRK LEV
OSC1
.0
1:1:1
WAV SUB PW SPD PWM
OFF OFF
OFF OFF
]
9
Parameter Set
10 per page