Electron ANALOG 4 Reference Manual page 30

Setting CV / Gate Settings
CV / GATE Settings
Function
PITCH V/OCT
PITCH HZ/OCT
VALUE LIN
TRIG
GATE
1. Select [FUNCTION] + [KEYBD C2] i.e. Global Mode
2. Select CV CONFIG option using (LEVEL) or [˄] or [˅] and [YES/SAVE] to
select
3. Select CV x CONFIG (where x is the selected channel A,B,C or D) option
using (LEVEL) or [˄] or [˅] and [YES/SAVE] to select
Or
1. Select [CV] i.e. CV Track
2. Select [FUNCTION] + [CV x] where x is the channel, A,B,C or D
3. Set up Configuration Use (LEVEL) control or [˄] [˅] buttons to change
parameter and [<] [>] buttons to change status.
TYPE, Type of Signal sent to the output, GROUNDED = Turns CV
•
Off, PITCH V/OCT, PITCH HZ/OCT, VALUE LIN, TRIG Note Start
Short Pulse, GATE Long Pulse at Note Duration.
See Table for further details
Parameter
MIDDLE C
Overall Pitch Tuning
TUNING
overall Tuning of Pitch CV
MIN
Lowest allowed voltage
level
LENGTH
Length of Trig signals sent.
Allows adjustment to match
equipment that needs
longer pulses
---
Parameter
V/OCT
Pitch width of signal
OCTAVE WIDTH
Pitch width of signal
MAX
Highest allowed voltage
level
POLARITY
Selects the polarity of trig
signals sent (V Trig or S
Trig) to match equipment
connected
30
Parameter
---
---
---
LEVEL
Sets Trig levels in volts,
typically 5V is adequate.