Table of Contents
Advertisement
Selecting a Pattern
Playing Pattern
Pausing Playback
Setting Tempo
Temporary Tempo Shift
Immediately Change Patterns
to beginning during playback
(Direct Start Pattern Mode)
1. Press [Bank Group] to select the group from which to choose a pattern.
Toggling the [Bank Group] switches between bank groups A-D and E-F.
2. Press [Bank A/E] or [Bank B/F] or [Bank C/G] or [Bank D/H] to select the
desired bank. Example Shows Bank E selected.
3. The Trig Key LEDs will illuminate half bright
pattern is loaded. Currently loaded pattern LED will show fully lit
4. Select a pattern, while the Trig LEDs are illuminated, by pressing one of
the illuminated [TRIG] buttons. The Pattern is then loaded and indicated on
the display.
KIT
_ _ : [
Patterns are named by the Bank + Trig Location, i.e. A01, E16 etc
1. Press [PLAY] to play the track
2. Select [STOP] to stop playback
3. To Stop all FXs and kill sounds press [STOP] [STOP]
Transport status is shown on the display
1. Press [PLAY] to Play the sequencer
2. Press [PLAY] while its running to Pause the sequencer
3. Press [PLAY] again to continue playback from paused position
1. Press [TEMPO] Button, Current Tempo is displayed
2. Use (LEVEL) control in units or [˄] [˅] buttons to adjust decimal setting.
Tempo is shown on the main display
1. Press [<] or [>] to shift Tempo +/-10% during playback or tempo setting
1. Press and toggle [FUNCTION] + [BANK GROUP]
2.
Red ☼
'Pattern Mode' LED indicates Direct Start mode is selected.
3. Select a new pattern. The pattern will start straight away from beginning
A
B
E
F
G
☼
☼
☼
OSC1
TUN FIN DET TRK LEV
120
OSC1
.0
■
1:1:1
g g g g - - - - YAZOO
YAZOO
YAZOO
YAZOO
WAV SUB PW SPD PWM
A01
]
A01
A01
A01
A01
13
C
D ☼
H
☼
☼
☼
for a few seconds where a
☼
OFF
OFF
OFF
OFF
Advertisement
Table of Contents
