Electron ANALOG 4 Reference Manual page 16

Quantize notes destructively
while recording
Immediately Change Patterns
to beginning during playback
(Direct Start Pattern Mode)
Immediately Change Patterns
at same step during playback
(Direct Jump Pattern Mode)
Change Pattern at the end of
current pattern to start of new
(Sequential Pattern Mode)
Copying / Pasting a
Sequencer Track Page
Clearing Sequencer Track
Page
Setting Length and timing of
all track patterns (SCALE
MENU - Normal Mode)
Quickly Changing Total
Pattern Length
1. While recording press [FUNCTION] + Press Encoder (D)
1. Press and toggle [FUNCTION] + [BANK GROUP]
2. Red ☼ 'Pattern Mode' LED indicates Direct Start mode is selected.
3. Select a new pattern. The pattern will start straight away from beginning
1. Press and toggle [FUNCTION] + [BANK GROUP]
2. Yellow ☼ LED 'Pattern Mode' indicates Direct Start mode is selected.
3. Select a new pattern. The pattern will start at the same synchronised step
to the previous playing pattern.
1. Press and toggle [FUNCTION] + [BANK GROUP]
2. Off ☼ 'Pattern Mode' LED indicates Sequential (default) mode.
3. Select a new pattern. The pattern will start at the end of the current
pattern.
1. Select Track eg [Trk 1]
2. Select GRID MODE by pressing [REC]
3. Select Track Page [Page]
4. Copy Page by Pressing [Page] + [REC] i.e. Copy
5. Select Destination Page, [Page]
6. Press [Page] + [STOP] i.e. Paste: Press Again for Undo
1. Select Track eg [Trk 1]
2. Select GRID MODE by pressing [REC]
3. Select Track Page [Page]
4. Clear by Pressing [Page] + [PLAY] i.e. Clear: Press Again for Undo
1. Select SCALE MENU by [FUNCTION] + [Page]
2. Select [<] or [>] to select and highlight SCALE section (lower bar
indicates area selected)
3. Select [˄] or [˅] to Select the NORM check box (Normal mode). All track
lengths are the same in Normal mode.
4. Select [<] or [>] to select and highlight PATTERN section, Left number =
Number of Steps Selected i.e. 64/64. Note: 16 steps per page of the seq.
5. Use (LEVEL) or [˄] or [˅] to adjust setting
6. Select [>] to move to right number, i.e. Total Step length 64/64
(16,32,48,64 are the available options)
7. Use (LEVEL) or [˄] or [˅] to adjust setting
8. Change Time Signature with far right most number (options are 1/8X,
1/4X, 1/2X, 3/4X, 1X, 3/2X, 2X). Select [>] to move to far right number
9. Use [˄] or [˅] to select time signature
Note: Extending Patterns will also copy over the existing trigs
1. Select SCALE MENU by [FUNCTION] + [Page]
2. Press [Page] to toggle through selected pattern length. Page LEDs
indicate Pattern length
16