Jayco SENECA Owner's Manual page 27

Contact you dealer
determining whether a separate braking
system is recommended for your towing and
traveling safety. Failure to follow these
instructions will create a safety hazard and
may result in an accident.
Maintenance
Keep the hitch clean along with your general
frame maintenance.
At the beginning of the season, and

monthly or thereafter, clean the inside of
the receiver tube with a wire brush and
spray with a silicone spray.
Always remove the utility mount from the

receiver when it is not in use. This will
help prevent the utility mount from rusting
to the tube.
Periodically check the bolts for tightness.

They need to be torqued to the proper
setting (refer to your Chassis Guide).
T P
RAILER LUG
If you choose to tow behind your RV, a
chassis manufacturer supplied 7-way trailer
plug (located at the hitch) is pre-wired into
your motor home. Wiring to operate your
towed vehicle brakes must be the same size
in both the towed vehicle and the motor
home.
White 1 Ground
Blue 2 Brakes
Green 3 Running lights
Black 4 House batteries charge line
Red 5 Stop & left turn
Brown 6 Stop & right turn
Yellow 7 Back up
for assistance in
Fig. 3.2
7-way trailer plug
Car end, rear view
PRE-TRAVEL INFORMATION
Maintenance
The connector plug may build up corrosion
with extended use and should be cleaned
periodically to insure good electrical contact.
Make sure the connector plug is kept clean
and protected from road elements as you
travel.
W L
EIGHT ABELS
The factory-installed weight labels are
specific to the recreation vehicle for which
they are supplied
interchangeable.
Vehicle weight labels are posted on Jayco
manufactured RVs so you can make an
informed decision before your purchase. Do
not remove these labels from your RV. If the
labels are missing, contact your dealer or
Jayco Customer Service for replacements.
Fig. 3.3 Federal Certification label
Fig 3.4 Motor home Weight Information label
SECTION 3
and are not
3 - 3