Transfer Channel List; Delete Cam Operator Profile; Satellite System - Samsung Smart TV E-Manual

Transfer Channel List

Broadcasting > Channel Settings
Imports or exports the channel map. When the PIN input screen appears, enter the PIN.
You should connect a USB storage device to use this function.
●
Import from USB: Import channel list from USB.
●
Export to USB: Export channel list to USB. This function is available when USB is connected.

Delete CAM Operator Profile

Broadcasting > Channel Settings
"
Availability depends on the specific model and area.
Select the CAM operator to delete.

Satellite System

"
Availability depends on the specific model and area.
Broadcasting > Channel Settings
A set of satellite dish settings must be configured for each wanted satellite before performing a
channel scan.
Satellite System is available when
the PIN.
●
Satellite Selection: You can choose the satellites for this TV.
●
LNB Power: Enables or disables the power supply for the LNB.
●
LNB Settings: Configures the outdoor equipment.
Satellite: Selects the satellite for receiving digital broadcasts.
Transponder: Selects a transponder from the list or adds a new transponder.
DiSEqC Mode: Selects DiSEqC mode for the selected LNB.
Lower LNB Oscillators: Sets the LNB oscillators to a lower frequency.
Upper LNB Oscillators: Sets the LNB oscillators to a higher frequency.
Tone 22 kHz: Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it should
be Auto.
●
SatCR/Unicable
"
SatCR is short for satellite channel router.
"
This function may not support depending on the country.
SatCR/Unicable: Enables or disable single cable installation support.
Slot Number: Select the SatCR user slot number for this receiver.
Slot Frequency: Enter the appropriate frequency to receive the signal from SatCR.
Detect Slot Frequency: Auto-detect the signal frequency for the selected slot number.
Verify Slot Frequency: Verify that the frequency entered corresponds to the selected slot.
> Transfer Channel List
> Delete CAM Operator Profile
> Satellite System
Aerial
Settings: Configure single cable installation.
Try Now
Try Now
is set to Satellite. When the PIN input screen appears, enter
Try Now
Try Now
Try Now