Table of Contents
Advertisement
Manual TV station presetting
The Auto CH Memory function (See
page 18) memorizes all broadcasts to
the suitable CH positions.
However some broadcast may not be
memorized due to weak signal. In this
case, use manual tuning function.
Note:
Occasionally, the auto search might catch
a weak signal and stop. If the TV station
signal is weak, you shouldn't store this
station.
In this case, restart the auto search us-
ing
or
.
22
Manual station presetting
You activate the auto search function until your preferred station is
tuned in. Then you memorize this station into the chosen channel
memory. Repeat this procedure for each station.
Preparation:
• Turn ON the TV and set to the AV input mode.
• Press VCR to select the VCR mode. (The VCR indicator will light.)
Example: Preset one station on program position 5.
1
Press VCR MENU.
Press
or
to select CHAN-
NEL SETUP. Then press EN-
TER.
2
Press
or
to select CH
TUNING. Then press ENTER.
3
B/G will blink. Press
select [ B/G ], [ D/K ] or [ I ]. Then
press ENTER.
4
DEC OFF will blink. Press EN-
TER. DEC OFF does not blink
anymore. SEARCH will appear.
Note:
If you wish to store the PRE-
MIERE manually, the decoder
must be connected as on the
lower of p.12.
During DEC OFF is blinking, press
DEC ON will blink now.
Press ENTER.
IMER REC SE
AU O REPEA
VCR SE UP
CHANNEL SE UP
SYS EM SE UP
SELEC :
EN ER : EN ER
EXI
:
MENU
CHANNEL SETUP
CH TUNING
AUTO TUNING
CHANNEL MAPPING
SELECT :
ENTER : ENTER
MENU
EXIT
:
or
to
D/K
DEC OFF
SELECT :
OK
:
ENTER
D/K
DEC OFF
SELECT :
OK
:
ENTER
.
[OFF]
CH 1
EXIT :
MENU
CH 1
EXIT :
MENU
Advertisement
Table of Contents
