Starting With A Dead Meter; Can Not Install The Software; Check The H/W And S/W Requirement; Error - Could Not Copy File - Seintek S2401 Service Manual

If you set the trigger level to normal (NOR) mode, trigger level
must be the same level of waveform. Meter does not trigger if
trigger level set above or below waveform.
If you set the trigger level to Auto (AT) mode, you do not need to
control the trigger level.
In rare cases, your instrument may require servicing. There are no
user-serviceable parts inside the instrument. For service, return the
instrument to your customer service center.
7.3.

Starting with a Dead meter

When you turn the Meter on, the display normally shows input
connections necessary for the function selected, then proceeds to a
display mode appropriate for that function.
A display that does not come on at all can be caused by a problem in
one or moreof several areas. These areas are discussed in the
following paragraphs.
7.4.

Can not install the software

7.4.1.

Check the H/W and S/W requirement:

1) IBM PC/XT/AT or Compatible Computer.
2) Microsoft Windows 3.1, 95, 98, 2000, XP or WINNT.
3) Serial Port for Connection with Instrument.
7.4.2.

Error - Could not copy file....

If message display "Error - Could not copy file : SETUP1.EX_
C:\WINDOWS (or WINNT)\setup1.exe", please deletion of
"WINDOWS (or WINNT)\setup1.exe" file and reinstall.
7-2