4-Installation And Assembly - RED LOTUS HYDRO Installation And User Manual

4-INSTALLATION AND ASSEMBLY

PREPARATION AND UNPACKING
The Lotus stove is supplied complete with all its electrical and mechanical components and factory-tested:
Open the package and remove the two screws between the bracket and the stove that fasten the bracket to the pallet.
Set the stove in the pre-selected place, making sure this complies with the requirements. The stove body or unit must always be kept in a
vertical position when handled and moved by using carts only. Pay particular attention that its door and its
FIGURE 1 - REMOVING THE PACKAGE SCREWS
glass are protected from knocks that might compromise their integrity.
Always handle the product with care. If possible, unpack the stove near the chosen place of installation. The materials that make up the
packaging are neither toxic nor harmful, and so require no particular disposal measures.
The product, as shown in figure 2, is equipped with a hook to ease handling.
After removing the packaging make sure that the stove is complete and not damaged:
if in doubt contact the dealer.
The product packaging contains the following documents:
• Instructions booklet
• Annex G - Technical inspection report for heat system with heat output below 35 kW.
• Warranty
22
FIGURE 2 - HOOK FOR HANDLING