Configuring The Modular Units; Attaching And Removing The Handle Unit - Canon EOS C100 Mark II Instruction Manual

Preparing the Camcorder

Configuring the Modular Units

34

Attaching and Removing the Handle Unit

The handle unit extends the camcorder's audio capabilities, adding XLR terminals as well as a built-in stereo
microphone.
Attaching the Handle Unit
1 Set the Q switch to OFF.
2 Insert the attachment base at the bottom of the handle unit to
the camcorder's accessory shoe.
3 Tighten the handle unit's lock screw while gently pressing it
down.
4 Connect the handle unit's cable to the camcorder's EXT
terminal, aligning the
Removing the Handle Unit
1 Set the Q switch to OFF.
2 Disconnect the handle unit's cable.
• Pull back the metallic tip of the cable to release the cable
and then disconnect the cable from the terminal.
3 Loosen the handle unit's lock screw and gently slide out the
handle unit from the accessory shoe.
NOTES
• You can use the accessory shoe or the socket for 0.64 cm (1/4 in.) screws on the handle unit to attach a
variety of commercially available accessories.
Configuration with handle:
Attach the handle unit to
use the built-in microphone,
XLR terminals, microphone
holder, etc. (A 84).
Minimal configuration with thumb rest.
Í
marks.
Light configuration with grip
for hand-held shooting.