Table of Contents
Advertisement
SURROUND
WITHOUT TRIM
FIGURE 7
1.4 FAN
Model ATS-AU-D has a factory installed Fan, Junction
Box, variable speed Rheostat Control Switch, and
Temperature Sensor Switch for the fan. The fan, tem-
perature sensor switch, and junction box are located
behind the lower grille. To provide the 240 VAC needed
at the Junction Box, simply plug the 3-prong grounded
cord into a 3-prong grounded 240 VAC wall outlet. This
cord exits the unit at the lower right hand corner.
1.5 INSTALLING THE SURROUND
NOTE:
REMOVE FRONT TRIM DOOR AND GLASS
DOOR ASSEMBLIES FROM THE INSERT BEFORE
SURROUND INSTALLATION.
1. Find the coiled low voltage wires and ON/OFF switch
attached to outer right side of the insert. See Figure 7.
2. Disconnect the ON/OFF switch from the low voltage
wire leads, and insert the short wires of the ON/OFF
switch through the hole at the upper right corner
of the surround and push the back of the switch
through the hole - it will be retained in the hole.
10
FIREBOX
DRESS GUARD
Heat & Glo • ATS-AU-D • 327-900 Rev. F • 6/09
SURROUND
ON/OFF
SWITCH
LOW VOLTAGE WIRES
3. Run the low voltage lead wires up the back of the
right side of the surround and secure them with
the three wire ties found there. Reconnect the low
voltage wires to the short wires of the ON/OFF
switch.
4. Remove and retain the four surround attachment
screws at the corners of the face of the unit. See
Figure 7.
5. Slide the surround against the face of the unit,
aligning the holes in upper and lower, right and left
corners and secure the surround to the unit with
the attachment screws.
NOTE: PLACE THE THREE INSULATION PIECES
INTO THE CAVITIES AT THE BACK OF THE SUR-
ROUND BEFORE POSITIONING THE INSERT INTO
THE FACTORY-BUILT OR MASONRY FIREPLACE.
THIS INSULATION WILL HELP SEAL FOR COLD
AIR LEAKS.
Hide quick links:
Advertisement
Table of Contents
