Table of Contents
Advertisement
Allow machine to sit for 5 minutes minimum to allow the power capacitors to discharge before
working inside this equipment.
Do not touch electrically live parts
The PROARC135 Inverter Welder requires a 240V 16A 50/60Hz supply (at 125 amps output it will
draw 13A input, if used on a 13Amp plug you may get nuisance fuse blows when welding at
maximum amperage). It comes with a 2 metre mains cable attached.
Connect wires according to national coding.
Brown wire – Live
Blue wire – Neutral
Green/Yellow Wire – Earth (Ground)
1. Negative welding power connector
Connect the earth cable dinse plug into here and twist to secure
2. Positive welding power connector
Connect the electrode holder cable dinse plug into here and twist to secure
Most popular rods require positive welding electrode and negative earth. If you are using special
electrodes please check manufacturer's recommendation for correct polarity of welding electrodes
and connect as required.
7
Front machine connections
Fig 1
Advertisement
Table of Contents
