Table of Contents
Advertisement
2.9.1 Setting the Controller
To perform mail transmission, enter the settings for accessing the mail server
(SMTP server).
1.
Show the setup screen from the controller operation panel.
2.
Select [Network Setup] — [Service Setup] — [E-Mail Setup] and enter
the following settings.
[Enable E-mail Services]:
[Outgoing Server]:
[Time Out (sec)]:
[Maximum Scan File Size]:
3.
Start PageScope Web Connection.
4.
Enter the password and log into the Administrator Mode.
Select "Yes".
Enter the IP address of the mail server (SMTP).
Set the timeout value for accessing the mail server.
Unless there is a specific reason to do so, use the
default value.
(common setting for the SMTP server and POP3
server)
Set the maximum transmission mail size.
2.9 Scan to E-Mail Function
2-23
Advertisement
Table of Contents
