U-Boot Configuration - Embest SBC8600B Quick Start Manual

HW ECC BCH8 Selected
NAND write: device 0 offset 0x0, size 0x8cef
36079 bytes written: OK
reading u-boot.img
234896 bytes read
HW ECC BCH8 Selected
NAND write: device 0 offset 0x80000, size 0x39590
234896 bytes written: OK
reading uImage
3224184 bytes read
HW ECC BCH8 Selected
NAND write: device 0 offset 0x280000, size 0x313278
3224184 bytes written: OK
reading ubi.img
14811136 bytes read
SW ECC selected
NAND write: device 0 offset 0x780000, size 0xe20000
Skip bad block 0x00ce0000
14811136 bytes written: OK
A Flashing LED on the board indicates that the update has been finished;
please remove the TF card and reboot the board.

4.1.3 U-boot configuration

The system image is set by default for a 4.3" LCD. You can change the
settings in UBOOT by using the instructions contained within the User
Manual.
Page | 16