Adjust Temperature And Change Programs Program Hold; Away Button (Vacation Mode) - Lennox icomfort Wi?Fi T Homeowner's Manual

Adjust temperature and change programs
Adjust temperature when programming is OFF
programming is OFF, the mode button (shown in figure 17, labeled heat
or cool) indicates a manual state (no mention of program"). In this
mode, change temperature by pressing a set temp button, which pro-
duces an up or down arrow, then use the arrows until the cool to" (or
heat to") number is at the desired temperature.
This setting will remain until you decide to change it again. (The inset
shows an alternate configuration of button layout in non−program mode.)
indoor temperature set temp
75
cool−to
70
heat to
indoor humidity is 41%
touch
cool−to
button
system is cooling
9:39 am January 23, 2012
Figure 17. Adjusting temperature with NO program running
Away Mode (Vacation)
screen sets the system for manual operation and allows you to set the
thermostat for energy saving while you are gone for an extended period
of time. In this mode, the system will only come on if indoor temperature
falls below a set degree (62 default for heating) or if indoor temperature
rises above a set degree (85 default for cooling). You may adjust those
settings as desired.
506921−01 04/12
away
mode
(mode
button)
heat
or
cool
set temp
fan is
75
AUTO
fan is fan is
AUTO OFF
cool−to
use arrows
to change
temperature
alternate
cool−only button
layout
?
The away mode button on the home
Turn Programming ON
When the
pressing the mode button (shown in figure 18, labeled heat or cool). The
manual settings menu includes an option to access programs. Select
programs. The program settings menu takes the place of the manual
settings menu. (Either menu will time out and disappear if you don't make
a selection within a few seconds). Select an option (e.g. spring/fall), The
menu disappears and the mode button will display the selected program
(e.g. spring...program is ON).
Turn Programming OFF
pressing the mode button (e.g. spring...program is ON). The program
settings menu includes an option for manual. Select manual. The menu
changes to the manual settings. Select one (e.g. heat only), The menus
disappear and mode button will display the selected manual option (e.g.
heat only).
cool
only
fan is
AUTO
indoor temperature
indoor humidity is 41%
system is waiting
9:39 am January 23, 2012
Page 14
If the programming is OFF, turn it on by
If the programming is ON, turn it off by
(mode
cool only
button)
set temp
heat only
78
heat
or heat or cool
cool
cool−to
70
emerg. heat
fan is
AUTO
fan is fan is
heat to
AUTO OFF
programs
use arrows
touch
to change
cool−to
temperature
button
Figure 18. Turning on the program
(program
settings (mode
menu) button)
summer
spring...
program
winter
is ON
off
spring/fall
save energy
custom
(manual
edit programs
settings
menu)
manual
?