Table of Contents
Advertisement
• Never use the appliance outdoors.
• Do not expose the appliance to atmospheric agents (rain, sun ...).
• Before cleaning the appliance always unplug it and allow it cool down.
Clean only with a non-abrasive cloth that has been slightly dampened with
water, adding a few drops of mild, non-aggressive detergent (never use
solvents that damage plastic).
• Do not place on or near a hot gas or electric burner, or in a heated oven.
KEEP THESE INSTRUCTIONS IN A
•
SAFE PLACE
DESCRIPTION OF THE APPLIANCE
A - On/off button
B - Control lever
C - Boiler temperature thermometer (°C and °F)
D - On indicator lamp
E - Boiler temperature control lamp
F - Steam function indicator lamp
G - Machine body
H - Water/steam dispensing lever
I - Water tank
J - Maxi Cappuccino attachment and wand for
water and steam supply
K - Pod filter holder
Identification data
The following machine identification data are shown on the plate found underneath the machine's standing
base:
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number
Always give the model and serial number to the Authorised Service Centres when requesting assistance.
PRELIMINARy PHASES FOR USE
Starting the appliance
Check that the voltage of the domestic network is the same as that indicated on the technical information plate
of the appliance. Place the appliance on a flat surface.
Wash the tank the first time it is used and fill it with cool tap water up to the level marked "MAX", then be careful
to put it back into its seat securely (Fig. 3) following the relevant guide on the bottom of its housing (Fig. 4). Make
sure that the control lever (B) is in the vertical standby position (Fig. 5). Insert the plug into the socket, which
must be earthed.
if water drips out of the pipe inside the tank, this does not mean the machine is faulty but it is a sign that
the priming valve is working normally.
Starting the first time
After having filled the tank up to the "MAX" level with cool tap water, start the machine by pressing the button (A).
The indicator lamp (D) will turn on, indicating that the machine is on, as well as indicator lamp (E), indicating that
the internal boiler is starting to heat up. Make at least one cup of water come out of the hydraulic circuit of the
boiler by pulling the control lever (B) forward and down, Fig. 8, until you see water come out of the filter holder
coupling seat (Fig. 9). Put the lever back in the vertical standby position.
6
L - Power cord
M - Cup-resting grill
N - Drip tray
O - Thermocream® Filter
P - Perforated silicone disc
Q - Thermocream® Disc
R - Filter holder
S - Spout for one cup
T - Spout for two cups
U - Coffee measure
V - Coffee presser
Hide quick links:
Advertisement
Table of Contents
